1.1/4 Pin
2.
3.Shield, chain plate
4.Sleeve 1/2 x 3/4 x 1/2
5.3/8 NC x
6.3/8 NC Flanged lock nut
Figure 27. Chain Shield Installed (RDC54 Only)
Full chain shielding, designed to reduce the possibility of thrown objects, must be installed when operating in populated areas or other areas where thrown objects could injure people or dam- age property. If this machine is not equipped with full chain shielding, operation must be stopped when anyone comes within several hundred feet.
1.Install chain shielding plate (3) to rear mower frame as shown.
2.Secure with carriage bolts (14) and flanged lock nuts (15).
3.Insert carriage bolts from bottom upward as shown.
Install Quick Hitch Kit (Optional) (RD60 & RD72 Only)
NOTE: Figure 28 shows RD60. Other models use the same assembly instructions.
NOTE: This kit allows mower to fit only Cat. 1 standard ASAE quick hitch.
1.Offset link, .38 x 2 x 25.88
2.38" Long chain
3.Sleeve, .91 x 1.44 x 1.25
4.1/2 NC x 6 Cap screw
5.1/2 Flat washer
6.Sleeve, .5 x .75 x 3.38
7.1/2 NC Flange lock nut
8.Sleeve, .875 x 1.125 x .593 HT
9.7/8 Flat washer
10.Sleeve, .81 x 1.25 x 1.81
Figure 28. Quick Hitch Kit Installation
1.Attach offset link (1) to mounting pins, using 7/8" sleeve (8) and flat washer (9). Do not tighten hardware.
2.Attach upper end of offset link to pivot link, using flat washer (5), sleeves (6 & 10), flange lock nut (7), and 1/2" x
3.Remove rear offset links and replace with chains
(2).
4.Attach chain to top of
5.Cut chain to length (RD60 - 40", RD72 45"). Vary length slightly as desired. Twist chain to make finite adjustments in length until unit lifts level.
NOTE: Do not bottom out the drive on front of deck.
6.Install sleeve (3) on mounting pins and retain with klik pin.
(Rev. 1/13/2006) MAN0260 (8/6/2004)
Assembly 29
