Instruction Sheet

Model D3276

Spray Gun

INTRODUCTION

The SHOP FOX® Spray Gun features a 1.5mm nozzle and 750cc paint canister that offers consistent spray patterns and fast coverage.

SETUP

The Model D3276 accepts 14" NPT connectors. Mount an air regulator as close as possible to the spray gun. Use the adjustment knob on the regulator to set your working air pressure between 65-85 PSI.

ADJUSTMENTS

See Figure 1 to identify the location of the spray gun controls and adjust in the following order:

1.Nozzle ControlAdjusts the spray pattern from vertical to horizontal.

2.Pattern ControlVariably adjusts the spray pattern from round to a wide fan.

3.Fluid ControlAdjusts how far back the trigger can be pulled, which affects the volume of paint released.

OPERATIONS

Hold the sprayer 8"–10" from the workpiece, and keep the spray gun perpendicular to the workpiece during strokes. DO NOT pivot your wrist when spraying!

MAINTENANCE

1.Clean the spray gun by flushing it with thinner.

DO NOT immerse the gun in the thinner!

2.To avoid internal damage, clean the air cap with the supplied brush.

 

Fluid

 

Control

Nozzle

 

Control

Pattern

 

Control

Figure 1. Model D3276.

EXPLOSION HAZARD! Do not

spray flammable fluids near

an open flame or ignition source.

EYE INJURY AND RESPIRATORY HAZARD! Always use safety glasses and respirator rated for paint and solvent vapors while using sprayer.

CUSTOMER SERVICE

For questions contact Woodstock International Technical Support at (360) 734-3482, or send e- mail to: tech-support@shopfox.biz.

COPYRIGHT © BY WOODSTOCK INTERNATIONAL, INC.

WARNING: NO PORTION OF THIS DOCUMENT MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC.

SEPTEMBER 2003, PRINTED IN CHINA.

Page 1
Image 1
Woodstock D3276 instruction sheet Instruction Sheet, Spray Gun, Fluid, Nozzle Control Pattern