Cutterhead and Roller Assembly Parts List | Jet Tools JPM-13CS

16.2.1Cutterhead and Roller Assembly – Parts List

16.2.2Cutterhead and Roller Assembly – Parts List

Index No	Part No	Description	Size	Qty
..................	MHA-CW	Dust Hood Assembly CP	......................................	1
1	MHA-C01AW	Dust Hood	......................................	1
2	TS-1503011	Hex Socket Cap Screw	M6x8	3
3	TS-0680021	Flat Washer	1/4	3
4	5FA-A10	C-Ring	STW15	2
5	PGA-C17	Sprocket	......................................	2
6	5GF-B08	Chain	......................................	2
7	MHA-C02	Feed Roller	......................................	2
8	PGA-C09	Spring	......................................	4
9	MGA-C09	Bushing	......................................	4
10	MHA-C03W	Head Body	......................................	1
11	TS-1504041	Hex Socket Cap Screw	M8x20	4
12	PGE-B19A	Handle Assembly	......................................	1
13	TS-2321041	Wing Nut	......................................	3
14	PGE-B19B	Bushing	......................................	1

24

Image 24

Jet Tools JPM-13CS operating instructions Cutterhead and Roller Assembly Parts List

Contents

Planer/Molder Part No. M-708524 Warranty and Service Warranty Period Table of contents Safety warnings Volts Total Length of Cord in Feet About this manual Electrical connections Grounding instructions115 Volt operation 230 Volt operation On-Off Switch Padlock Specifications JPM-13CS Glossary Setup and assembly Adjustments Planing Feed rate adjustment Knife adjustmentAdjusting V-Belt Tension Knife replacement Adjusting infeed roller and outfeed rollers for planing Planing procedure Adjusting chip deflectors for planingDealing with warped wood Molding setup and adjustments Installing molding cuttersWood Grain For 2 and under cutters Setting feed rollers for molding Making & installing a bedboard Guide rail placement and attachmentMaking guide rails Molding procedure Setting table height for first pass Maintenance Disconnect machine from power source unplugBack Relief Molding Tongue and Groove Molding Troubleshooting the JPM-13CS Mechanical and electrical problemsTrouble Probable Cause Remedy Performance problems Replacement Parts Table and Base Assembly Exploded View Table and Base Assembly Parts List Index No Description Size Qty Cutterhead and Roller Assembly Parts List PGE-B19C Gearbox Assembly Parts List MHA-G Stand and Motor Assembly Parts List PJA-C03 Electrical Connections Page New Sanford Road LaVergne, Tennessee Phone