7.0 Specifications
Model number |
|
Stock Number | 708524 |
Capacities: |
|
Maximum Cutting Width | 13” (330 mm) |
Maximum Thickness | |
Full Width Depth of Cut | 1/16” |
Minimum Planing Length | 14” (356 mm) |
Cuts per Minute | 13,500 |
Feed Rate, Planing | 20 fpm |
Feed Rate, Molding | 10 fpm |
Cutterhead: |
|
Number of Knives | 3 |
Knife Size | |
Cutterhead Diameter | |
Cutterhead Speed (RPM) | 4500 |
Motor and controls: |
|
Motor type | totally enclosed fan cooled, induction, capacitor start |
Horsepower | |
Phase | single |
Voltage | 115/230V (prewired 115V) |
Cycle | 60Hz |
Listed FLA (full load amps) | 15/7.5 A |
RPM | 3450 |
Start capacitor | 400MFD, 125VAC |
Power transfer | |
On/off switch | push button |
Motor speed | 3450 RPM |
Power plug installed | 120V |
Recommended circuit and fuse/breaker size1 | 30A (115V), or 15A (230V) |
1 subject to local/national electrical codes. |
|
Dust collection: |
|
Dust port outside diameter | 4” (100mm) |
Minimum extraction volume required | 350 CFM (18CMM) |
Dimensions and weights: |
|
Overall Dimensions | |
Net Weight (approx.) | 225 lb (102 kg) |
Shipping Weight (approx.) | 262 lb (119 kg) |
The specifications in this manual were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.
IMPORTANT:
∗The use of a dust chute and adequate dust collection system is highly recommended but not required for most planing operations.
∗The use of a dust chute and adequate dust collection system is required for all molding operations.
For a complete line of woodworking dust collectors, contact your local JET distributor, or visit our website at www.jettools.com.
8