Jet Tools JPM-13CS operating instructions Table of contents

2.0Table of contents

Section				Page
1.0 Warranty and Service				2
2.0	Table of contents			3
3.0	Safety warnings			4
4.0	About this manual			5
5.0	Electrical connections			6
5.1		Grounding instructions		6
5.2		115 Volt operation		6
5.3		230 Volt operation		6
6.0	On-Off Switch Padlock			7
7.0	Specifications			8
8.0	Glossary			9
9.0 Setup and assembly				10
9.1		Shipping contents		10
9.2 Unpacking and cleanup				10
9.3 Assembly				10
10.0	Adjustments: Planing			10
10.1		Depth of cut		10
10.2		Adjusting depth of cut scale		10
10.3		Feed rate adjustment		11
10.4		Adjusting V-Belt Tension		11
10.5		Knife adjustment		11
10.6		Knife replacement		12
10.7		Adjusting infeed roller and outfeed rollers for planing		12
10.8		Adjusting chip deflectors for planing		13
11.0	Planing procedure			13
11.1		Dealing with warped wood		13
11.2		Wood Grain		14
12.0 Molding setup and adjustments				14
12.1		Installing molding cutters		14
12.2		Setting feed rollers for molding		15
12.3		Making & installing a bedboard		16
12.4		Making guide rails		16
12.5		Guide rail placement and attachment		16
13.0 Molding procedure				17
13.1		Setting table height for first pass		17
13.2		Back Relief Molding		18
13.3		Tongue and Groove Molding		18
14.0 Maintenance				18
14.1		Lubrication		18
15.0 Troubleshooting the JPM-13CS				19
15.1		Mechanical and electrical problems		19
15.2		Performance problems		20
16.0 Replacement Parts				21
16.1.1 Table and Base Assembly – Exploded View				22
16.1.2 Table and Base Assembly – Parts List				23
16.2.1			Cutterhead and Roller Assembly – Parts List	24
16.2.2			Cutterhead and Roller Assembly – Parts List	24
16.3.1 Gearbox Assembly – Parts List				26
16.3.2 Gearbox Assembly – Parts List				27
16.4.1 Stand and Motor Assembly – Parts List				28
16.4.2 Stand and Motor Assembly – Parts List				29
17.0	Electrical Connections			30

3