Speed.Changes
To.change.the.drilling.speed,.do.these.steps:
1... UNPLUG.THE.DRILL.PRESS!
2.. Loosenthebelttensionlockknobsonthe
sideoftheheadstock(seeFigure.35).
3. Locatethedesiredspeedonthechartand
movetheV-belttothedesiredV-grooves
onthemotorandspindlepulleys(see
Figure.36).
4.. Pushthemotorinward,andmovetheV-
belt to the right spot.
5.. Push the motor toward the back of the
headstock. The motor support rod is spring
loaded and will follow the motor. Tighten
the lock knob when the right tension is
achieved.
6. Close the cover.
UNPLUG. the. drill. press.
before. changing. speeds.
to.avoid. accidental.start.
up..Failure.to.do.this.may.
result.in.serious.personal.
injury.
TheModelW1669andW1670RadialDrillPress
has5speedsrangingfrom550to3470 RPM.
To find your needed drilling speed and pulley
combination, refer to the speed chart located
underthebeltguard;orgoto.Page. 22 and
refer to the Drill.Press.RPM.Chart.
Figure.35..Looseninglockknob.
Figure.36..Adjustingbelttodesiredspeed.
Never.operate.drill.press.
with. belt. cover. in. the.
open.position..Your.hand.
may.become.trapped.in.a.
belt.and.serious.personal.
injury.will.occur.
Pushrod
OPERATIONS
-21-