ADJUSTMENTS
Gas Spring Locations
The gas spring can be positioned in 1 of 3 loca- tions to allow clearance for different board thicknesses or to mortise a board on edge. To determine which setting to use, look at the chart in Figure 21 and find the board thickness that most closely fits your workpiece. Note the number that corresponds with that board. This will be the position number shown in Figure 22. Follow the instructions on the following page to place the gas spring in the new location.
8½” |
4½” |
2½” |
Figure 21. Maximum board thicknesses.
ADJUSTMENTS
1 2
3
