-18-
Figure 24. Workpiece clamped to edge of table.
Pivot Feature
The head and column assembly can be adjusted
for mortising off of the base. This will allow the
mortising machine to accommodate a larger
workpiece than those previously listed. To
change the position of the head and column
assembly:
1. Support the head with the hand lever and
unlock the depth stop lock knob. Allow the
depth stop rod to touch the base surface
and secure the rod in place.
2. Loosen the two hex nuts in the pivoting
base.
3. Rotate the assembly to the desired angle.
4. Tighten the hex nuts.
5. The worktable should be removed before
operating the machine.
Secure the workpiece with clamps before
using the machine. See Figure 24.
Figure 26. Setting micro-adjusting block.
Figure 25. Drill bit must extend beyond chisel.
Fence Adjustments
ADJUSTMENTS
The fence is supplied with a fine adjusting
assembly, a spring and a collar. These enable
centering the chisel to the workpiece quickly
and with accuracy.
1. Support the head with the hand lever and
unlock the depth stop lock knob. Allow
depth the stop rod to touch the base surface
and secure the rod in place.
2. Loosen the locking lever for the fence.
3. Use a pencil to mark the mortise on the
workpiece.
4. Install the mortising chisel with the drill bit.
The drill bit must be positioned so the end
extends beyond the chisel body for proper
chip clearance. See Figure 25.
WRONG