ASSEMBLY
Table Support
1.Thread the 12mm table lock handle 3 turns into the table support bracket.
2.Insert the pinion into the hole on the side of the table support bracket from the inside, starting with the pinion shaft. Figure 9. Align setscrew in crank handle with flat, Figure 10, on pinion shaft and secure using the 3mm Allen® wrench provided.
3.Examine the rack and note that the gear teeth extend further on one end than the other.The shorter end must be positioned down. Insert the rack into the table support bracket and align with pocket. The end of the rack where the gear teeth are closest to the end should be positioned down as in Figure 11. The gear teeth on the rack must also face out.
