Disc Sander Components, Machine Identification

SAFETY

Figure 1. Machine Identification.

1. Base

2. Miter Gauge

3. Dust Port

4.Table Lock Handle

5.Work Table

6.Precision Ground Disc (Sanding Disc Attached)

7.Disc Guard

8.Motor

9.ON/OFF Switch

-6-

Image 8

Contents

Disc Sander Page Contents About Your New Disc Sander Woodstock Service and SupportIntroduction Warranty and Returns Specifications Disconnect machine when cleaning, adjusting or servicing Safety FirstStandard Safety Instructions #16 #14 11-12 13-16 #12 17-20 #10 21-30 Keep stable footing and balance at all times Disc Sander Components Machine Identification Additional Safety Instructions for Disc Sanders Disc Sander Electrical Requirements 110V OperationExtension Cords Grounding Assembly Box ContentsOverview Shop Preparation Cleaning Machine Adjustments Adjusting TableGeneral Information To align the table with the disc plate, do these steps Table Tilt Replacing SandpaperTo check table tilt, do these steps To replace the sanding disc, do these steps Operations Test RunDisc Sanding To perform sanding operations, do these steps Miter Sanding Angle SandingTo perform miter sanding operations, do these steps To perform angle sanding operations, do these steps Lubrication MaintenanceGeneral Closure 22-3 22-1 22-5 22-4 22-2 Parts List Warranty Card BOX BELLINGHAM, WA