Woodstock W1736 instruction manual Assembling Overarm Router, Set

W1736 Overarm Router

Assembling Overarm

Router

1.Using four M10-1.5 x 45 cap screws and lock wash- ers, attach the support arm to the table with the rubber gasket in the middle (see Figure 3).

2.Mount the head assembly to the support arm with four M10-1.5 x 25 cap screws and lock washers (see Figure 3), and tighten evenly.

3.Attach the side guard to the head assembly with two flat head screws (see Figure 3).

4.Thread the round adjustment nuts onto the shaft, and slide the rubber washer over the shaft and up against the round adjustment nuts.

5.Insert the shaft into the head assembly and tighten the lock nut onto the end of the shaft (see Figure 4).

6.Install the front guard with two flat head screws, taking care not to break the guard by overtightening (see Figure 5).

7.Install the router safety guard with the two thumb- screws and plastic washers, taking care not to break the guard by overtightening (see Figure 5).

8.Thread the table pin knob bolt into the front of the table (see Figure 5). (It may help to lift the table so you can see where the shaft needs to thread into the table.)

9.Install the cord loop with the M4-.7 x 12 flange screw (see Figure 5).

-9-

Side Guard	Head to
to Head	Support Arm
	Rubber
	Gasket
Support Arm
to Table		SET
Figure 3. Initial assembly of support arm,
		UP
head assembly, and side guard.
Shaft

Round Nuts

Rubber Washer

Lock Nut

Figure 4. Shaft, round nuts, rubber

washer, and lock nut installed.

Front Guard	Cord Loop
	Router
Table	Safety
	Guard
Pin Knob

Figure 5. Front and router guards, cord

loop, and table pin knob installed.