Woodstock W1824 manual G8IKJ

Df[\cN(/)+('?pYi`[KXYc\JXn

GIF9C<D		GFJJ@9C<:8LJ<		:FII<:K@M<8:K@FE
Blade is not aligned with	1.	Blade is warped.	1.	Replace blade (see Page 27).
miter slot or fence.	2.	Table top is not parallel to blade.	2.	Make miter slot parallel to blade (see Page 60).
	3.	Fence is not parallel to blade.	3.	Make fence parallel to blade (see Page 66).
Blade does not reach 90°.	1.	90° stop collar is out of adjust-	1.	Adjust 90° stop collar (see Page 58).
		ment.
	2.	Sawdust stuck on stop collar.	2.	Clean sawdust off stop collar.
Blade hits insert at 45°.	1.	45° stop collar is out of adjust-	1.	Adjust 45° stop collar (see Page 59).
		ment.
	2.	Sawdust stuck on stop collar.	2.	Clean sawdust off stop collar.
	3.	Slot in insert is inadequate.	3.	File or mill the slot in the insert.
	4.	Table out of alignment.	4.	Align miter slot to the blade (see Page 60).
	5.	Blade position is incorrect.	5.	Adjust blade position.
Board binds or burns when	1.	Dull blade.	1.	Replace blade (see Page 27).
feeding through table saw.	2.	Blade is warped.	2.	Replace blade (see Page 27).
	3.	Fence is not parallel to blade.	3.	Make fence parallel to blade (see Page 65).
	4.	Table top is not parallel to blade.	4.	Make miter slot parallel to blade (see Page 60).

G8IKJ

-73-