Woodstock W1824 manual Slots before fully tightening the fasteners

J<KLG

		Df[\cN(/)+('?pYi`[KXYc\JXn
9.	Attach the front rail to the table and extension
	wings with (4) M8-1.25 x 35 flat head screws, 8mm
	flat washers, 8mm lock washers, and M8-1.25 hex	:fjVa
	nuts, as shown in Figure 17.
	Note: Make sure the top of the rail is parallel with
	the table top surface along its entire length and
	below the miter slots before fully tightening the
	fasteners. This will ensure that the fence will ride	x4
	evenly across the table top.
10.	Attach the rear rail to the table with (2) M10-1.5
	x 25 hex bolts, 10mm lock washers, and 10mm flat
	washers, as shown in Figure 18.

Figure 17. Front rail attached parallel

Note: As with the front rail, make sure the rear railwith the table top. is parallel with the table top and below the miter

slots before fully tightening the fasteners.

11. Secure the rear rail to the extension wings with (2)
M8-1.25 x 35 hex bolts, (4)	8mm flat washers, (2)	x2
8mm lock washers, and (2)	M8-1.25 hex nuts, as
shown in Figure 18.

x2

12.Install the extension table between the front and rear rails with (2) M8-1.25 x 35 hex bolts, (2)

M8-1.25 x 35 flat head screws, (8) 8mm flat washers,

(4) 8mm lock washers, and (4) M8-1.25 hex nuts, as shown in Figure 19. Finger tighten the fasteners for now.

13.Place the straightedge across the main table, right wing, and extension table, make sure the extension table is even with other top surfaces, then fully tighten the fasteners.

Figure 18. Rear rail attached parallel with

the table top.

x2

x2

Figure 19. Extension table installed.

-18-