Model W1824 10" Hybrid Table Saw
ELECTRICAL
Voltage Conversion
The Model 1824 is prewired for a 220V power supply, but it can be rewired to operate on a 110V power supply. To reduce the risk of electrocution, machine damage, or an electrical fire, this procedure must be performed by an electrician or qualified service personnel. The procedure involves moving terminal jumpers inside the motor junction box, replacing the machine circuit breaker, and replacing the plug on the power cord.
The require machine circuit breaker can be purchased from an authorized Shop Fox dealer. The required plug and receptacle can be purchased from your local hardware store or it may be provided by your electrician.
Items Needed | Qty |
Phillips Screwdriver #2 | 1 |
NEMA | 1 |
Circuit Breaker 20A (Part No. | 1 |
To convert the table saw to 110V, do these steps: |
|
1.DISCONNECT TABLE SAW FROM POWER!
2.Open the motor junction box, then loosen the four screws indicated in Figure 4.
3.Remove the two center jumpers (they are stacked together), reposition them as shown in Figure 5, then
4.Close and secure the motor junction box.
5.Remove the START/STOP switch box from the switch mounting plate.
6.Replace the
7.Replace the existing power cord plug with a NEMA
This manual was current at the time of printing. However, if the motor wiring diagram provided on the inside of the junction box cover differs from this manual, always use the junction box cover wiring diagram. This should reflect any changes that may have occurred after printing.
Motor Prewired for 220V
Loosen
These
Screws
Center Jumpers <gdjcY
Figure 4. Locations of screws to be
loosened.
Motor Rewired |
for 110V |
<gdjcY |
New Jumper Locations |
Figure 5. Relocated jumpers.
Circuit |
Breaker |
