Woodstock W1828 owner manual Attaching Sandpaper, To attach the sandpaper disc, do these steps

Model W1828 (For Machines Mfg. Since 4/11)

Attaching Sandpaper

The Model W1828 sander uses 12" diameter pressure sensitive adhesive-backed (PSA) sanding discs. These are available in a variety of grits. The sandpaper can be replaced without removing the table.

To attach the sandpaper disc, do these steps:

1.DISCONNECT MACHINE FROM POWER!

2.Peel-off the old sandpaper, and clean the disc surface with mineral spirits, and wipe dry.

3.Peel back the protective layer on one-halfof the sandpaper disc and fold it against the remaining half.

4.Slip the half with the protective layer between the disc and the table edge, as shown in Figure 14.

5.Position the exposed adhesive on the upper half of the sandpaper disc over the aluminum disc above the table. Once it is positioned evenly across the disc, press the adhesive firmly onto the surface.

6.Now rotate the disc so the lower half is above the table, peel-off the other half of the protective paper, as shown in Figure 15, then press the sandpaper disc firmly against the disc so adhesion is complete.

Figure 14. Slipping covered sandpaper

between disc and table.

OPERATIONS

Figure 15. Removing the paper backing.

-19-