Xantech 490-95

Page 2 Model 490-95

INSTALLATION

These units, equipped with a 7-foot cable and 3.5 mm stereo mini plug, are intended to be plugged direct ly into the "IR

RCVR" or "AUX" jack on Xantech Connecting Blocks, such as the CB12(incl uded), CB60, 789-44, 791-44, etc. The 490-

95 should be used in installations where the connecting block is withi n reach of the 7-foot cable -- such as when installing

the 490-95 in a cabinet where the controlled equipment is behind closed doors.

PLACEMENT

Placement of the IR Receiv er does matter when

used in the presence of a Plasma Display. Ideal ly it

should be placed at areas around the Display with

the front of the receiver f lush with the front of (or

set back from) the Display. If t he 490-95 needs to

be placed in front of the display (such as on an

adjacent side wall perpendicular to the display),

make sure it is placed at a location at l east 45

degrees off axis from the corners of the unit – see

Figure 1. The presence of Direct Sunlight and

Fluorescent Lighting should not effect the

reception of this unit.

Note: Plasma interference can be refl ected off of any item it comes into contact with within approx. 3 ft . from the front of

the display. Keeping this in mind, m ake sure that the 490-95 is free of any obstruction that m ight reflect back into the

receiving eye.

Note: While this unit shows strong rejection to standard 50/ 60Hz ‘ballasted’ fluorescent lighting, it is still prone to

interference from CFL style F luorescent lighting.

MOUNTING

1. Drill a 0.75” (19mm) hole in any flat surface, such as a cabinet panel.

2. Pass the lead and the body of the 490-95 through the hole.

3. Secure from the rear with the W asher and Nut (all supplied) as shown in Figure 2a. Be sure not to over-tighten

nut.

1.25

0.90

2.75

0.75

Figure 2a – 490-95 Features Figure 2b – 490-95 Dimensions

45° 45°

PLASMA DISPLAY

Figure 1 – 490-95 Placement