Xantech IR-DC4 installation instructions IR/RS232 Interface Module, Features and Specifications

INSTALLATION INSTRUCTIONS

IR-DC4

IR/RS232 INTERFACE MODULE

The IR-DC4 is an IR to RS232 Interface Module. Specifically, the IR-DC4 converts certain Xantech RC68 Remote Programmer IR control codes into RS232 commands that operate the Arrakis Digilink 4 Hard Disk Audio Jukebox. This allows the unique advantages of the Arrakis Jukebox to be easily integrated into Xantech IR-controlled whole house music systems. Refer to the Arrakis DC4 Users Manual for complete configuration and operational details.

DB9F RS232

OUTPUT PORT

	IR-DC4
IR IN
IR GND
PWR GND	IR/RS232
+12VDC	INTERFACE MODULE
® SYLMAR, CA

Fig. 1 The IR-DC4

FEATURES AND SPECIFICATIONS

•IR Signal & Power Inputs:

Plug-in screw-type terminals for four-conductor connections. Handles wire sizes from 24 to 12 gauge.

•Opto-Coupled IR IN Input and Separate IR Gnd permits IR input to be isolated from chassis and power supply grounds, where needed.

•RC68 Remote Programmer Code Settings for the Arrakis DC4 Control Protocols are as follows:

Code Setting	Arrakis DC4
D-1	Player #1
D-2	Player #2
D-3	Player #3

•Accepts IR control signals from the IR outputs of any of the Xantech IR Receivers, Keypads, Connecting Blocks, Controllers, etc.

•Output: RS232 DB9F connector.

•Power Requirements: 12 VDC ± 1.5 V @ 20 mA.

•Mounting: Flanges, plus supplied screws, permit easy mounting to flat surfaces.

•Dimensions: 4-3/8" L x 1-7/8" W x 1-1/4" H (110mm x 47mm x 32mm)

RC68 PROGRAMMER

The RC68 Programmer (available separately) contains the commands necessary for IR operation of the DC4 through the IR-DC4.

•Use it to program universal learning devices such as learning remotes, the Xantech Smart Pads, Controllers, etc.

•NOTE: The RC68 codes operate many other Xantech models as well, therefore, only the button descriptions that apply to the operation of the DC4 (Overlay "F") are listed on the next page.

 1

Modules & Connecting Blocks