Model MRC88m / MRAUDIO8x8m | Page: 37 |
INCLUDED HARDWARE & SOFTWARE ITEMS
The MRC88m Dragon
•DragMRC CD ROM
•One DB9
CONNECTING THE MRC88M CONTROLLER/AMPLIFIER TO THE PC
To program the MRC88m Controller/Amplifier, the unit will need to be connected to a PC for programming.
DB9 SERIAL CONNECTION
Connect the supplied DB9 cable to your PC serial port and the other end to the DB9 connector labeled RS232 COM on the front panel of the MRC88m – Figure
USB SERIAL CONNECTION
Connect one end of the USB cable (not included) to the USB port of your PC and the other end to the connector labeled USB COM on the front panel of the MRC88m – Figure
NOTE: The USB connection requires a ‘B’ Type connector to interface with the MRC88m. Connecting a cable into this port will automatically override any device connected to the RS232 COM port on the front of the MRC88m
SOFTWARE INSTALLATION
Windows 98/ME/NT/2000/XP
Install the DRAGMRC program onto your hard drive as follows:
1.Insert the disc into your computer’s
2.On the Welcome menu, click NEXT.
3.Follow the
NOTE: For the convenience of the installer, the Dragon
STARTING MRC88M DRAGON DROP-IR™ SOFTWARE
1.From START menu, choose Programs.
2.Select Xantech and click on the DragMRC Icon from the menu.
3.The program loads and opens to the Xantech MRC Dragon
SERIAL PORT SELECTION
When first launched, the Dragon
NOTE: If you are using the USB port, see the instructions below on Configuring the USB Port.
To configure the USB Port for the first time, complete the following instructions:
1.Turn the system ON and then turn the PC ON.
2.Connect the USB cable from the PC to the USB connector on the front of the MRC88m Controller.
3.A New Hardware window should appear on the PC. Click NEXT to search the drive for an available driver. For File Location point the system to C:\Program Files\DragMRC\USB folder.
© 2009 Xantech Corporation