Xantech MRKP2 - FRONT PANEL, RJ45 Connector at, Controller/Amplifier, Cable, at Keypad

MRKP2 – FRONT PANEL

Figure 2.1: T568A and T568B Wiring Standard

RJ45 Connector at

Controller/Amplifier	Wire Color	Pin #	Signal
	white/orange	1	485	+
	orange	2	485	-
	white/green	3	12V RET
	blue	4	IR RET
	white/blue	5	IR

NAVIGATION BUTTONS

UP, DOWN, LEFT, RIGHT,

ENTER/SELECT (center button)

	MAIN
	DISPLAY
SCAN
FWD/RRW	scan
	volum e
	skip
TRACK SKIP
NEXT/PREV

PAUSE STOP

POWER

ON/OFF

INTERNAL IR SENSOR

“ X” (SETUP)

VOLUME

UP/DN

MUTE

PLAY

		green	6	+12V
		white/brown	7	Attn. 485
		brown	8	IR Loop Back
Cat 5	RJ45 Connector
Cable		Wire Color	Pin #	Signal
	at Keypad
		white/orange	1	485 +
		orange	2	485 -
		white/green	3	12V RET
		blue	4	IR RET
		white/blue	5	IR
		green	6	+12V
		white/brown	7	Attn. 485
		brown	8	IR Loop Back

Figure 2.2: MX88 – MRKP2 Pin-out diagram for Cat-5 cable

(T568B configuration)

8

Figure 2.3: MRKP2 Keypad layout and Main display

Notes:

∙Tone Control functions of the MRKP2 can be entered by pressing the Next arrow once inside a source control page. Please note that each of the three controls can be returned to their center position by tapping the center of each bar.

∙Unlike older keypads, and due to the unique and streamlined functional set-up of the MRKP2E’s buttons, “press-and-hold” tier 2 functions are not supported. However, Tier 2 button IDs and the macros underneath them are available through Universal Dragon.

9