Xantech MRKP2 Setup, External IR Receiver Connections, Initial Power-up, QuickConfig

External IR Receiver Connections

Use an external Xantech IR Receiver in cases where a hand-held remote needs to be pointed somewhere other than at the MRKP2 or in cases where additional interference requires the use of a different type of IR receiver or IR receiver mounting location. Typical IR Receiver locations are near a TV or other equipment such as a Local Source (DVD Player, A/V Receiver,…etc.). A CAT-

5 cable can be used to extend the IR receiver’s wire, if necessary. Refer to the bottom of the Specifications section (page 19) for wiring instruction when using CAT-5 cable to extend the IR signal.

By default, the MRKP2 External and Internal IR receivers are both active. Having both active, in some cases, can cause issues with IR signal reflection and/or multiple processing of the same IR command. In such specific cases it is advisable to disable the Internal IR when using an external IR receiver. The internal IR receiver can be disabled by removing jumper clip JP3 as shown below.

4. MRKP2 Setup

Initial Power-up

Whenever the MX88 or the keypad itself is reset, the MRKP2 will take approximately 1 minute to initialize. During most of this period of time, with the exception of first 5 seconds, the On/Standby LED will be illuminated in green as an indication that boot-up is in progress.

QuickConfig

The Xantech QuickConfig feature facilitates the setup of the MX88 system from a keypad without the use of a PC. Please refer to the QuickConfig Guide at www.xamtech.com/MX88 for details on setting up QuickConfig.

Set-up menu

To access the Main Setup Menu, press and hold down the “X” key for at least 5 seconds.

IRSENSOR ENABLEJUMPER (JP3)

TO MRC88m

CONTROLLER

XANTECH

IRRECEIVER

+12VDC GND IRIN

XANTECH CORP.

MRKP2 - 050710000077

Reset button

Once the Main Setup Menu is displayed on the touch screen simply touch and release the listed item to access more information or to make adjustments.

TO EXPANSION

KEYPAD

IROUT GND

IN-ZONEIR

EMITTER

Figure 3.1: MRKP2 to External IR Connections

14

Information - See Fig. 4.1

Backlight Settings – See Fig. 4.2

Installer Settings – See Fig. 4.3

Save and Exit - Leave the Main Setup Menu and go back to normal display mode and save changes

Exit without Saving - Leave the Main Setup Menu and go back to normal display mode without saving changes

15