When the board is properly positioned, the tabs on the chassis will fit through the corresponding slots in the system board.
cSlide the system board tray toward the back of the chassis until the retention pin snaps into place.
3Reconnect the power cables to connectors PWR1, PWR2, and PWR CTRL on the system board. See Figure
4Reinstall the CPU processor(s). See "Replacing a Processor" on page 88.
5Reinstall the memory modules. See "Installing Memory Modules" on page 83.
6Reconnect all cables to the connectors on the front edge of the system board.
7Reinstall the TOE key, if applicable. See Figure
8Reinstall the
a Align the
b Gently push the bracket toward the back of the chassis until the latch on the left side of the bracket and rear plunger engage.
9Install all expansion cards. See "Installing an Expansion Card" on page 57.
10If applicable, reinstall the SAS RAID controller daughter card. See "Installing the SAS RAID Controller Daughter Card" on page 95.
11If a RAC card is present, attach the cables to the RAC connectors on the system board. See "Installing a RAC Card" on page 85.
12Reinstall the center and rear fan brackets. See "Replacing the Center Fan Bracket" on page 79 and "Replacing the Back Fan Bracket" on page 80.
13Install the memory cooling shroud. See "Installing the Cooling Shroud" on page 79.
NOTICE: Never operate your system with the memory cooling shroud removed. Overheating of the system can develop quickly resulting in a shutdown of the system and the loss of data.
14Install all of the cooling fans. See "Removing and Installing a Fan" on page 53
15Reconnect all cables to the expansion cards.
16Close the system. See "Closing the System" on page 48.
17Reconnect all cables to the front and rear of the system.
18Reconnect the system to the power source and turn on the system and attached peripherals.
19Replace the front bezel, if removed. See "Installing the Bezel" on page 47.
100
