Figure 3-28. Removing the System Board

4

1

2

3

1 system board

2

system board handles (3)

3

chassis hooks

4 retention pin

Installing the System Board

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.

1Unpack the new system board.

2Install the system board.

a Hold the system board by its front edge and the system board handles. See Figure 3-28.

b Carefully lower the system board into the chassis with the DIMM-socket side of the board tilted down slightly to allow room for the board to clear the chassis wall slides. Ensure that the I/O connectors on the back edge of the board fit underneath the ledge on the inside of the chassis back panel.

Installing System Components

99

Page 99
Image 99
Dell 1900 owner manual Installing the System Board, Retention pin