Dell 1900 owner manual Installing an Internal Scsi Tape Backup Unit, Power cable, Peripheral bay

Figure 3-15. Installing and Removing the Half-Height Tape Backup Unit or Optical Drive

1

2

3

4

		5
1	SCSI ribbon cable	2	power cable	3	release latch
4	peripheral bay	5	half-height tape backup unit or
			optical drive

Installing an Internal SCSI Tape Backup Unit

This subsection describes how to configure and install an internal SCSI tape backup unit.

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Remove the front bezel, if attached. See "Removing the Bezel" on page 46.

3Open the system. See "Opening the System" on page 48.

68

Installing System Components