Removing LCD Status Messages

For faults associated with sensors, such as temperature, voltage, fans, and so on, the LCD message is automatically removed when that sensor returns to a normal state. For example, if temperature for a component goes out of range, the LCD displays the fault; when the temperature returns to the acceptable range, the message is removed from the LCD. For other faults, you must take action to remove the message from the display:

Clear the SEL — You perform this task from the system management software, but you will lose the event history for the system.

Power cycle — Turn off the system and disconnect it from the electrical outlet; wait approximately ten seconds, reconnect the power cable, and restart the system.

Either of the preceding actions will remove fault messages and return the status indicators and LCD colors to the normal state. Error messages will reappear under the following conditions:

The sensor returns to a normal state but fails again, resulting in a new SEL entry.

A new error event is detected.

A failure is recorded from another source that maps to the same display entry.

System Messages

System messages appear on the screen to notify you of a possible problem with the system. Table 1-5 lists the system messages that can occur and the probable cause and corrective action for each message.

NOTE: If you receive a system message that is not listed in Table 1-5, check the documentation for the application that is running when the message appears or the operating system's documentation for an explanation of the message and recommended action.

CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.

Table 1-5. System Messages

Message

Causes

Corrective Actions

 

 

 

Alert! Redundant memory

Installed memory modules are not the

Ensure that all memory modules are of

disabled! Memory

same type and size; faulty memory

the same type and size and that they are

configuration does not

module(s).

properly installed. See "Memory" on

support redundant memory.

 

page 80. If the problem persists, see

 

 

"Troubleshooting System Memory" on

 

 

page 110.

 

 

 

Attempting to update

Remote Configuration request has

Wait until the process is complete.

Remote Configuration.

been detected and is being processed.

 

Please wait...

 

 

About Your System

23

Page 23
Image 23
Dell 1900 owner manual System Messages, Removing LCD Status Messages