Appendix: Installation
3. INSTALLATION OF INDOOR UNIT
3.1 Take off the back cover
1)Release the clips as shown by the mark "" on the back cover.
2)Take off the back cover.
3.2Drilling
1)Locate the back cover of the indoor unit on the wall, and determine the desired place with a spirit level and a ruler. Before drilling, do not fix the back cover onto the wall.
2)According to direction of the tube ,drilling for tubes according to the location of the appliance. It is recommended that the rear right be used for wiring and drilling.
3)Drill a 65mm hole in the wall (Figure 6), make sure the hole is inclining to the outside .
Indoor Outdoor
|
| Figure 6 |
! |
| Before drilling, make sure that |
| there is no electric cable or pipe | |
CAUTION | in the area of the wall where the | |
|
| hole is to be drilled. |
3.3 Installation of the back cover
1)check with a spirit level that the back cover is installed horizontally. (Figure 7)
Figure 7
2)fix the back cover to the wall with the screws provided. (Figure 8). Make sure that the back cover is firmly fixed to he wall.
Figure 8
3.4 Install the indoor unit
1)Thread the cable through the hole in the wall, an additional 13cm of slack power cable should remain inside the room. (Figure 9)
Back cover
Lining cover
Electrical cable
13cm | Figure 9 |
2)Unload the bottom cover of indoor unit with flat screw driver, and according to direction of lining tube, leave the cutting part of left bottom or right bottom cover with saw.(figure 10)
Cutting part
Figure 10
3)Bind the electrical cable drainage hose, refrigerant tube, air exchange tube together tightly with white adhesive tape; the electrical cable, refrigerant tube and the electrical cable are fixed on the back of indoor unit with wedged slab, bend the refrigeration tube and make the electrical cable and the air exchange tube through hole of the wall smoothly(figure 11).
Lining cover
Back cover
Refrigerant tube
Electrical cable
Air exchange tube
Figure 11
4) Install the dismantled bottom cover to indoor unit(figure 12).
C
B
A
Figure 12
5)Adjust the position of the indoor unit, fixing it firmly onto the back cover(figure 13).
Figure 13
24