Hisense Group KF-5002GWE manual Installation of the Outdoor Unit, Wiring

Appendix: Installation

3.5 Wiring

(1)Before wiring, make sure the rated voltage indicated on the

nameplate conforms to the local power voltage.

(2)Wiring should be carried out in accordance with the

instructions on the electrical schematic diagram (Figure 14).

Terminal		Terminal
Panel of		Panel of
the indoor		the outdoor
	unit		unit
1			1

2 2

3 3

Figure 14

!WARNING

Wi ring for connection of the indoor unit and the outdoor unit should be conducted in accordance with local regulations.

Wiring connections must be fitted firmly.

The electrical wires should not be in contact with any of the refrigeration tubes, compressor or other moving parts or components.

The appliance must be connected to a good earth.

3.6Wiring connection of the indoor unit

1)Hold pull and open the front cover.

2)Release the screws and open the wire distribution cover (Figure 15).

Wiring distribution cover

Figure 15

3) Connecting cable should be placed along the back of the indoor unit to the front for connection.

4)Connect the wire distribution terminals and corresponding terminals .(Figure 16)

Figure 16

5)Check the connections and then fasten the distribution cover and replace the front cover finally.

4. INSTALLATION OF THE OUTDOOR UNIT

Properly locate the outdoor unit as described by the Section 2.

If the outdoor unit is to be mounted on the wall ,make sure that

the wall and the support are strong enough for the appliance.

Wiring Connection

1)Release the fixing screws and take off the side cover.

2)Connect the terminals on the heap pump as required in the Figure 14 and the Figure 17:

3)Always save an extra 10cm length of the electrical cable:

4)Earth the appliance according to related regulations of electrical engineering:

5)Fix the connected terminals with clips and replace the side cover if the connection is assured according to the wiring diagram:

Wiring distribution cover

Figure 17

25