Installation

Calculating Size of DC Input Cables for XPower 1750 Plus

Refer to Table 3-3to plan the DC cabling:

Keep all cables as short as possible, and ensure that each cable between the inverter and the battery is no longer than 6 feet (1.8 m).

Do not use aluminum cable. It has about 1/3 more resistance than copper cable of the same size, and it is difficult to make good, low- resistance connections to aluminum wire.

Xantrex recommends that you use oil resistant cable.

Table 3-3 Recommended DC Input Wire Sizes & Lengths: XPower 1750 Plus

 

RV1 (Recreational Vehicle) and Marine2

Cable length:

 

 

Battery to Inverter

 

Maximum Battery

(one way)

Minimum Cable Size

Fuse Size

 

 

 

2 feet (0.6 m)

No. 1/0 AWG

250 Adc

6 feet (1.8 m)

No. 1/0 AWG

250 Adc

 

 

 

Note: Never use a cable longer than 6 feet (1.8 m) with the XPower 1750 Plus. Appropriate size cable can be bought at a welding supply house or a marine supply store.

1.Based on US National Electrical Code NFPA70, Article 551 and Table 310- 17, 90C cables located outside of engine spaces.

2.Based on ABYC (American Boat and Yacht Council) Recommended Practice E-9, Table IV, 75C cables located outside of engine spaces, maximum 3% volt- age drop.

3–10