Using the DC cable clips
By directly connecting the power inverter to a 12 V battery using the DC cable clips (if supplied), you can operate products with power requirements up to 360 W continuous.
1.Follow steps 1 and 2 under “Using the DC cable with cigarette lighter plug” to attach the
2.Attach the negative (black) clip to the negative
3.Attach the positive (red) clip to the positive (+) battery terminal. Make sure both clips are securely connected to the battery terminals, as a loose connection will cause the voltage to drop and may cause the cables to overheat, resulting in equipment damage or fire.
4.Switch the power inverter “ON”.
5.When the power inverter is not in use, disconnect the DC cable clips from the battery to prevent slight discharge of battery.
Hardwiring the inverter to the battery
A hardwiring illustration is shown in Figure 1.
SHOCK AND FIRE HAZARD
Have a qualified installer perform a hardwired installation.
Failure to follow these instructions can result in death or serious injury.
13
