Xantrex Technology 1400i Restarting After an AC Output Shutdown, Changing the Audio Alarm Setting

Operation

Restarting After an AC Output Shutdown

1.Press and hold the unit’s power switch button to turn it Off.

2.Remove all AC loads or let the unit cool down for 15 minutes.

3.Press and hold the unit’s power switch button to turn it On.

Changing the Audio Alarm Setting

1.Press and hold the power switch button for five seconds. NOTE: You will hear a beep after holding the button for about one second. Keep holding the button for five seconds more to change the alarm setting.

2.Observe the message on the digital display.

If you see a L 1 being displayed, this indicates that the audio alarm is enabled even during warning conditions. If you see a L 0 being displayed, this indicates that the audio alarm is disabled.

NOTE: Factory setting is a L 1 .

3.Release the button to which setting you want.

NOTE: Holding the power switch button continuously for more than five seconds at a time will cycle the alarm setting to a L 1 then to a L 0 and so on until the button is released.

Operating Limits

Power Output

The PROwatt SW will deliver the following power continuously, depending on input voltage and ambient temperature. The inverter will deliver more than 10% of its continuous power rating for approximately five minutes.

Model	Powera	Currentb	Voltage	Temp.
PROwatt SW 700i	700 W	3 A		Ambient
PROwatt SW 1400i	1400 W	6 A
			12.5 Vdc	25 °C
				(77 °F)
PROwatt SW 2000i	2000 W	8.7 A

a.Applies to resistive loads such as incandescent lights. b.Applies to reactive loads such as motors.

975-0525-01-01 17