Installation
2–4 975-0402-01-01
This guide for use by qualified installers only
Tools and Materials
To mount and connect the Truecharge™ 2 Battery
Charger you need the following tools:
• 10 mm socket wrench and extension for the DC terminals
and ground stud
• Phillips screwdriver for removing and re-securing the AC
and DC wiring compartment covers
• power drill/screwdriver
• drill bit for pilot holes for mounting screws (if using #6
mounting screws, use 1/16 drill)
• wire stripper
• manufacturer's recommended crimp tool for any crimp
terminals that are being used
You need the following materials:
• 3 conductor AC input wiring
Use the information in “Installing AC Wiring” on
page 2–20 and your local electrical codes to determine
the correct wire and breaker or fuse.
• AC cable strain relief (if the one included is not
compliant with your local electrical code requirements)
• appropriately sized DC cables for each battery, with
suitable connectors at the battery end
Use the information in “DC Wiring” on page2–8 and
your local electrical codes to determine the correct wire
and breaker or fuse.
• appropriately sized DC chassis ground (earth) with
suitable connectors
• ring terminals to fit 6 mm (1/4 in.) studs at the charger
end (Marine grade hardware is recommended).
• DC fused disconnect or properly rated circuit breaker for
each battery bank
• mounting screws, M3 or #6 marine grade, corrosion
resistant (4 pieces) (Length dependent on mounting
surface).