XEROX FREEFLOW SCANNER 665HINTS AND TIPS
Table
# | Feature/Function | Hints/Tips |
|
|
|
|
|
|
5 | Fast Preview | It is recommended that you leave the PC monitor screen resolution at the |
|
| default setting when the system is installed (1024 x 768). If the screen |
|
| resolution is changed from this default, the rulers on the scanner preview |
|
| window may be covered by the preview image, particularly with smaller, |
|
| custom sized originals. |
|
|
|
6 | More - Pictorial | The Brightness, Contrast, and Advanced Image Adjustment controls will |
| Rendering | not function if the “Pictorial Rendering” selection (found in the “More” button |
|
| on the “Image Quality” tab) is changed to “Threshold” for any “Original |
|
| Type” other than “Text and Line Art.” |
|
|
|
7 | Background | Background suppression has improved significantly as compared to the |
| Suppression | “DocuImage 620S Scanner” and the “Production Scanner”. Specifically, the |
|
| “Normal” selection will remove the background on the wider range of |
|
| background darkness levels. Documents with darker backgrounds or |
|
| darker colored stocks that previously required background suppression |
|
| settings of “Strong” or “Very Strong” may no longer require these settings. |
|
|
|
8 | SCSI scanner | It is important to ensure the connectors on the SCSI interface cable that |
| connection | connects the scanner to the PC is properly seated and the thumbscrews |
|
| holding the connector are tightened. If the screws on the connector are not |
|
| tightened, the connections, particularly on the scanner, may become loose |
|
| over time, resulting in one of the following fault codes: |
|
|
|
9 | System calibration | The scanner image quality may vary slightly for the first 20 - 30 minutes of |
|
| operation if the scanner has been turned off for an extended period of time. |
|
| If the scanner has been turned “off” for longer than 48 hours, it is |
|
| recommended that you calibrate the scanner immediately prior to scanning |
|
| a job for the first 20 - 30 minutes of operation after powering on. |
|
|
|
10 | Windows “Found | Upon a reboot of the scanner and the PC, Windows may occasionally |
| New Hardware” | display a “Found New Hardware” message, despite having completed a full |
| message | installation of the scanner hardware. Assuming the devices were rebooted |
|
| in the proper sequence (scanner first, until the “Ready” light is lit, then the |
|
| PC), this message can be ignored by selecting “Cancel” from the “Found |
|
| New Hardware” dialog. |
|
|
|
11 | Pictorial rendering | Changes made to the “Pictorial rendering” selection, followed by a change |
| warning message | in the “Original Type” selection, may yield a warning, noting that the |
|
| pictorial rendering has been automatically changed (“Warning - setting |
|
| change - the following setting will be reset: Pictorial rendering”). |
|
| NOTE: The “Pictorial rendering” selection is located by selecting the |
|
| “More” button on the “Image Quality” tab of the scanner driver. |
|
|
|
12 | Printing Help | If you attempt to print the full contents of “Help” (Go to Help and choose the |
|
| heading “Solving Problems”, then choose to print “selected heading and all |
|
| subtopics”), the last subtopic entitled “Clearing Jams and Misfeeds” does |
|
| not print and must be printed separately. |
|
|
|
CUSTOMER SOFTWARE RELEASE SUPPLEMENT |
