Installing Your LCD Monitor

Introduction

Follow the instructions below to set up and install the monitor.

1The package contains:

1.Display unit

2.Stand

DISPLAY UNIT

STAND

2Cover an even stable surface with a soft cloth. Place the unit face-down on the cloth. Fit the stand onto the bottom of the display unit as shown.

3 Use a coin to tighten the screw on	4
the bottom of the stand until the

screw is ﬁrmly ﬁxed in place.

10	Xerox© LCD Monitor User’s Manual

Image 11

Contents

Page 2004 by Xerox Corporation. All rights reserved Introduction Table of ContentsInstallation Federal Communications Commission FCC Statement ENGLISH Federal Communications Commission FCC Statement Warnings Important Safety Instructions Do not touch the power cord and antenna cable during lightning d. The product has been dropped or damaged a. The power cord or plug is damagedb. Liquid is spilled into the product c. An object falls onto or into the product 1 Introduction Features Power cord specification H05 VV-F 3G 0.75mm2 Package Contents 2 DOWN/UP 5 POWERFront View and Controls 1 MENU Installing Your LCD Monitor Method 1 Analog D-SUB Connection 2 InstallationConnecting Your LCD Monitor to a Computer 2 Connect to the DVI port Method 2 DigitalDVI Connection POWER/ button Using Your LCD Monitor5o 20o EXIT Using the OSD Menu3 OSD MENU Contrast PhaseThe OSD Options Brightness WARM ColorSelect User Mode COOL Language Reset Dot X Line Preset Mode Timing ChartVideo signal IBM PC/AT 4 Technical Information DESCRIPTION DVI Connector PIN Assignment SCL FOR DDC D-SUB Connector PIN AssignmentDESCRIPTION Red Green Blue Ground Self Test Red Ground Green Ground Blue Ground 5 VDC Ground Ground SDA FOR DDC H. Sync V. Sync Example Plug and PlayVisual Inspection Permanently unlit or lit pixels Poor picture or abnormal picture TroubleshootingMonitor will not turn on No picture