adhere to the vehicle’s surface. Make sure you accurately place the pad on the first try since in many cases it will bond almost immediately. 3M recommends a
3. Clip the Roady2 onto the swivel or vent mount (figure 7).
4. Reassemble the system as in step 1, inserting cassette audio adaptor
into the vehicle’s cassette deck and the
12V power adaptor into the cigarette lighter.
5.Attach the antenna as explained on page 22 and route the antenna cable as described
on page 24. | Figure 7. Attach car mount to back of |
| Roady2 as shown. |
Removing swivel mount from your dashboard
You can remove the swivel mount from your dashboard by taking the following steps:
1.Lift one edge of the adhesive pad gently with fingers or the rounded edge of a spoon. Once enough of the edge is loosened to grip with your fingers, pull the pad gently from the mounting surface at a
2.If the pad fails to loosen, first warm it with a hair dryer for 2 to 3 minutes to soften the adhesive. Be careful not to apply too much heat, which could damage the mounting surface.
3.If any adhesive remains on the dashboard surface, the adhesive can easily be removed by rubbing your thumb or
finger across it.
4.As necessary, use a mild household cleaner to clean the dashboard surface.
21
