tango_x2_manual_eu_new.qxd 1/25/08 3:51 PM Page 7
Unpacking and Initial Setup
1.Remove Tango X2 from the box and remove foam and protective plastic. Keep original packaging for 90 days and then properly dispose.
2.Place Tango X2 on a level surface following the precautions listed in the safety warnings. For best sound, make sure to leave some room between the back of the unit and a back wall so that air can pass through the bass port.
3.Remove AC adapter, remote and AM/FM antennas from the packaging.
4.Read and review manual and safety warnings
5.Connect the AC adapter into the jack on the back of Tango X2 labeled “18V DC ”, then plug the AC adapter into the wall outlet.
6.Connect the FM antenna into the “FM” jack on the back of the unit. Untie and extend the antenna.
7.Connect the AM antenna into the “AM” jack on the back of the unit.
Listening to your iPod
1.Remove the plastic cover protecting the dock connector and dispose of properly.
2.Use the insert that came with your iPod and gently press it into the universal dock well.
3.Carefully place your iPod into the dock well
4.Press the control wheel on the front of the unit or press power on the included remote to turn on the power. The display will light “iPod” to indicate the unit is powered up and an iPod is properly docked. The display will turn off after 10 seconds.
5.Press play on the top of the unit, on the iPod or on the remote.
6.Turn the control wheel on the front of the unit or use the volume controls on the remote to adjust the volume to the desired level.
7.Use the controls on the top of the unit or the remote to play/pause and for next/previous track. For more advanced functions, use the iPod controls.
8.Press and hold the control wheel on the front of the unit for 2 seconds to turn of the power. To conserve energy, the unit will automatically power off if no audio is detected after 7 minutes.
Note: If you dock a playing iPod, the unit will automatically switch to iPod mode and start playing. If you dock an iPod that is not playing, it will automatically switch to iPod mode, but you will have to press play on the unit, the remote or the iPod itself.
Tango X2 User’s Guide 5
