Other changes 11
The signal can be now directly output just before the Input
channel HPF. You can also adjust the direct output level.
To select a position just before the HPF as the direct output on
the INSERT/DIRECT POINT screen, turn on the PRE HPF
button for the corresponding channels in the DIRECT OUT
POINT column. The DIRECT OUT LEVEL column will indi-
cate the direct output levels. However, to adjust the level, use
the INSERT/DIRECT VIEW screen.
To select a position just before the HPF as the direct output in
the INSERT/DIRECT VIEW screen, turn on the DIRECT but-
ton located just before the HPF. Use the LEVEL knob located in
the lower right corner of the screen to change the direct output
level. The direct output levels are not linked even if the corre-
sponding two channels are paired.
Hint
• These settings are saved in scene memories.
• If you load data that was saved in a System Software version
older than version 2.0, the direct output level will be set to 0 dB.
The default direct output point is PRE EQ.
More functions are available that can be assigned to the USER
DEFINED [1]–[8] switches.
The following functions have been added:
*This function is enabled only when an effect that features the TEMPO
parameter is selected. The USER DEFINE switch LED flashes at the
specified tempo while and after you set the tempo. For more information
on the Tap Tempo function, please refer to page 51 of the PM1D System
Software Version 1.5 Supplementary Manual.
Direct output just before the HPF
INSERT/DIRECT POINT
DIRECT OUT POINT column
PRE HPF buttonDIRECT OUT LEVEL column
INSERT/DIRECT VIEW
DIRECT button LEVEL knob
Additional functions for the USER DEFINE switches
FUNCTION PARAMETER Explanation
GEQ SELECT GEQ1–24 Display the GEQ PARAM-
ETER screen.
TAP TEMPO*
CURRENT
Uses the Tap Tempo func-
tion available on the dis-
played screen.
EFFECT1–8
Uses the Tap Tempo func-
tion available for the
specified effect.
TC EVENT
NEXT EVENT
RECALL
Recalls the subse-
quently-numbered event.
PREV EVENT
RECALL
Recalls the previously-
numbered event.
DIRECT EVENT
RECALL
Recalls the specified
event registered on the
TC EVENT screen.
ENABLE/DIS-
ABLE
Switches between the
ENABLE button and DIS-
ABLE button on the TC
EVENT screen.
ENABLE[ALL
MANUAL]/DIS-
ABLE
Switches between the
ENABLE [ALL MANUAL]
button and DISABLE but-
ton on the TC EVENT
screen.
TALKBACK
DIRECT
ASSIGN
MIX 1–48,
MATRIX 1–24,
STEREO,
MONITOR B
Send the talkback signal
to the specified output
channels. (If you turn it
off, the previous talkback
setting will be used.)
USER DEFINE