CONNECTIONS
2Connecting to an amplifier not equipped with a subwoofer (line out) terminal
Connect an amplifier (and front speakers) to this unit using commercially available speaker cables. Refer to the following instructions to make connections.
■Connecting to the speaker cable | ■Banana plug connection |
1 2
10 mm (3/8”)
3
4
2 
1 Tighten the knob.
1
5
1 Remove approximately 10 mm (3/8”) of insulation from each of the speaker cables.
2 Twist the exposed wires of the cable together to prevent short circuits.
3 Turn the knob counterclockwise to loosen.
4 Insert the bare wire into the hole in the side of each terminal.
5 Turn the knob clockwise to tighten.
6 Test the firmness of the connection by pulling gently on the cable at the terminal.
Notes
2 Insert the banana plug connecter into the end of the corresponding terminal.
•Do not let the bare speaker wires touch each other, because this could damage this unit or the amplifier, or both of them.
•For connection, keep the speaker cables as short as possible. Do not bundle or roll up the excess part of the cables. If the connections are faulty, no sound will be heard from this unit or the speakers, or both of them.
•Make sure that the + and – polarity markings of the speaker terminals are observed and set correctly. If these cables are reversed, the sound will be unnatural and lack bass.
•Do not insert the insulation into the hole. The sound may not be produced.
9En