Quick Guide
Step
4
Adjusting Level
1 Adjust the volume on all instruments that are connected to the AUDIOGRAM interface.
Set the OUT LEVEL control to the minimum position. Failure to do so may result in loud noise bursts that can damage your equipment, your ears, or both.
CAUTION
2
3
Adjust the channel LEVEL controls so that the level indicator PEAK LED flash briefly on the highest peak levels.
Adjust the overall volume with the OUT LEVEL control while monitoring via headphones or monitor speakers.
OUT LEVEL control
LEVEL controls | Level indicator |
Step
5
Recording with Cubase AI
This section describes the procedure for recording to the Cubase AI software we installed earlier via the AUDIOGRAM interface.
NOTE For details on operation of the Cubase AI software refer to the
Cubase AI Setup
1
2
Set the computer output to the maximum level.
For details on how to make the setting refer to the “The recorded sound is too low in level.” section in the “Troubleshooting” on page 20.
Launch Cubase AI.
Windows:
Click [Start] → [All Program] → [Steinberg Cubase AI 4] → [Cubase AI 4] to launch the program. If the ASIO Multimedia dialog window appears, click [Yes].