Quick Guide
4 To hear playback of the track you have just recorded, use either the Transport panel [Rewind] button or the ruler to rewind to the beginning of the recorded section, then click the Transport panel [Start] button.
The overall playback level will be displayed via the master section bus level meter on the right side of the mixer window, and the channel level will be displayed via the channel strip level meter.
NOTE • Click the [Narrow/Wide] button in the upper left corner of the mixer window to increase the width of the mixer’s channel strips.
•To hear the playback sound via the AUDIOGRAM interface, adjust the volume with the OUT LEVEL control.
The playback level will approximately match the recording level when the computer output is set to the maximum level.
[Narrow/Wide] button | [Narrow/Wide] button | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Level meter | Bus level meter |
5
6
7
To save the project file select [Save] from the [File] menu and enter a file name before actually saving the file.
Save your project file frequently to insure against losing large amounts of data if a problem occurs.
Repeat steps 1 through 5 to record further material on the same track.
To record additional material on a different track, select a new track and repeat the record procedure.
Recording with maximum quality and minimum noise:
For optimum sound quality with minimum noise, the AUDIOGRAM signal levels should be set as high as possible without clipping. Check signal levels to be sent to Cubase AI for recording using the AUDIOGRAM level indicators while the Cubase monitoring button (
) is turned off. Adjust the chan- nel LEVEL controls so that the level indicator PEAK LEDs flash only occasionally on the highest input transients.
Monitoring button
AUDIOGRAM 3 Owner’s Manual | 15 |
