A unit and cart combination should be moved with care.
Quick stops, excessive force, and uneven surfaces may cause the unit and cart combination to overturn.
SAFETY INSTRUCTIONS

1Read Instructions – All the safety and operating instructions should be read before the unit is operated.

2Retain Instructions – The safety and operating instructions should be retained for future reference.

3Heed Warnings – All warnings on the unit and in the operating instructions should be adhered to.

4Follow Instructions – All operating and other instructions should be followed.

5Water and Moisture – The unit should not be used near water – for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc.

6Carts and Stands – The unit should be used only with a cart or stand that is recommended by the manufacturer.

6A

7Wall or Ceiling Mounting – The unit should be mounted to a wall or ceiling only as recommended by the manufacturer.

8Ventilation – The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, the unit should not be situated on a bed, sofa, rug, or similar surface, that may block the ventilation openings; or placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings.

9Heat – The unit should be situated away from heat sources such as radiators, stoves, or other appliances that produce heat.

10Power Sources – The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the unit.

11Power-Cord Protection – Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the unit.

12Cleaning – The unit should be cleaned only as recommended by the manufacturer.

13Nonuse Periods – The power cord of the unit should be unplugged from the outlet when left unused for a long period of time.

14Object and Liquid Entry – Care should be taken so that objects do not fall into and liquids are not spilled into the inside of the unit.

15Damage Requiring Service – The unit should be serviced by qualified service personnel when:

A.The power-supply cord or the plug has been damaged; or

B.Objects have fallen, or liquid has been spilled into the unit; or

C.The unit has been exposed to rain; or

D.The unit does not appear to operate normally or exhibits a marked change in performance; or

E.The unit has been dropped, or the cabinet damaged.

16Servicing – The user should not attempt to service the unit beyond those means described in the operating instructions. All other servicing should be referred to qualified service personnel.

17Power Lines – An outdoor antenna should be located away from power lines.

18Grounding or Polarization – Precautions should be taken so that the grounding or polarization is not defeated.

FCC INFORMATION

1. IMPORTANT NOTICE : DO NOT MODIFY THIS UNIT!

Compliance with FCC regulations does not guarantee that

This product, when installed as indicated in the

interference will not occur in all installations. If this product

instructions contained in this manual, meets FCC

is found to be the source of interference, which can be

requirements. Modifications not expressly approved by

determined by turning the unit “OFF” and “ON”, please try

Yamaha may void your authority, granted by the FCC, to

to eliminate the problem by using one of the following

use the product.

measures:

2. IMPORTANT : When connecting this product to

Relocate either this product or the device that is being

accessories and/or another product use only high quality

affected by the interference.

shielded cables. Cable/s supplied with this product

Utilize power outlets that are on different branch (circuit

MUST be used. Follow all installation instructions.

breaker or fuse) circuits or install AC line filter/s.

Failure to follow instructions could void your FCC

 

authorization to use this product in the USA.

In the case of radio or TV interference, relocate/reorient the

3. NOTE : This product has been tested and found to

antenna. If the antenna lead-in is 300 ohm ribbon lead,

comply with the requirements listed in FCC Regulations,

change the lead-in to co-axial type cable.

Part 15 for Class “B” digital devices. Compliance with

If these corrective measures do not produce satisfactory

these requirements provides a reasonable level of

results, please contact the local retailer authorized to

assurance that your use of this product in a residential

distribute this type of product. If you can not locate the

environment will not result in harmful interference with

appropriate retailer, please contact Yamaha Electronics

other electronic devices.

Corp., U.S.A. 6722 Orangethorpe Ave, Buena Park, CA

This equipment generates/uses radio frequencies and, if

90620.

not installed and used according to the instructions

The above statements apply ONLY to those products

found in the users manual, may cause interference

distributed by Yamaha Corporation of America or its

harmful to the operation of other electronic devices.

subsidiaries.

 

2