REMOTE CONTROL “LEARNING” FUNCTION

The keys on this remote control transmitter can be programmed to “learn” key-functions from other remote control transmitters.By using this feature, this unit can then be used in place of one or more other remote control transmitters, thus making operation of your various audio and video components more convenient. Moreover, each key can learn two functions by switching the learning page. Use the included user program sheets to indicate a new function learned for each key.

Note

There may occasionally be instances, due to the signal-coding and modulation employed by the other remote control transmitter, that this unit will not be able to “learn” its signals.

To Learn a New Function

1

Set to a desired learning page.

2

USER

RS LEARN

Set to the “LEARN” position.

3 Press a key on this unit where a new function will be

learned.

About 5–10 cm (2–4 in.)

This unit

Other remote-control

transmitter

Illuminates.

4 Press and hold the key (on the other remote control transmitter) where the desired new function is.

When the TRANSMIT/LEARN indicator stops illuminating, the learning is finished.

5 Repeat the step 3 and 4 until all desired functions are successfully learned.

6 Set to the “USER” position.

USER

RS LEARN

Try operating your components.

Notes

●When you operate the desired component with this remote control transmitter, TRANSMIT/LEARN indicator will flash steadily.

●The originally preset function of a key is still available in the USER position if a new function has not been learned to the key.

●Successful learning to a key results in the erasure of previously learned functions and their replacement by the newly learned ones.

●If there is no more room in the memory area for a function to be learned, the TRANSMIT/LEARN indicator will flash two times. In this case, even if some keys are not occupied with functions from other remote control transmitters, no further learning is possible.

Memory back-up

All of the learned functions will be retained while you replace the batteries. However, if no batteries are installed for a few hours, the learned functions will be erased and will have to be learned again.

Blank keys (Refer to the previous page.)

These keys have no preset functions and are used only for learning other remote control transmitter’s functions.

1/2 switch (To switch the learning page)

This switch changes the learning page (1 or 2) of the all the keys except the shaded keys shown below in “A/B switch”.

A/B switch (To switch the learning page)

This switch changes the learning page (A or B) of the shaded keys shown below instead of the 1/2 switch.

FRONT EFFECT LEVEL

 

A B

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CENTERLEVEL

MUTING

 

 

 

 

 

DELAY

 

 

 

 

MASTER

 

 

 

 

 

TIME

 

 

 

 

VOLUME

 

REARLEVEL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

RESET CLEAR

RESET button

Press this button to “reset” the internal microcomputer which controls remote control operations. Microcomputer “reset” is necessary when the remote control freezes.

21