To Clear a Learned Function
1 | USER |
| |
RS | LEARN | ||
|
Set to the “USER” position.
2 Press and hold the CLEAR button using the point of a mechanical pencil, etc.
CLEAR
3 Press and hold the key where the learned function to
be deleted is until the indicator flashes 3 times.
To clear two or more functions, repeat steps 2 and 3.
Note
If a key is not pressed soon after the CLEAR button is pressed, this unit will automatically return to the status that was in effect before the CLEAR button was pressed.
To Clear All Learned Functions
1 |
| USER | LEARN | ||
RS | |||||
|
|
|
|
|
|
|
|
|
|
|
|
Set to the “LEARN” position.
2 | Press and hold the CLEAR button using the point of a | |||
| mechanical pencil, etc. | |||
| CLEAR | |||
|
|
|
|
|
3 | Press and hold any key until the indicator flashes 7 | |||
| times. | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
NOTES ABOUT THE REMOTE CONTROL TRANSMITTER
Battery installation | Remote control transmitter operation range |
Battery replacement
If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones.
Notes
●Use only “AA”, LR6,
●Be sure the polarities are correct. (See the illustration inside the battery compartment.)
●Remove the batteries if the remote control transmitter will not be used for an extended period of time.
●If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.
Within approximately 7 m (23 feet)
30 |
| ° |
° | 30 | |
|
|
Notes
●There should be no large obstacles between the remote control transmitter and the main unit.
●If the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp etc.), it might cause the remote control transmitter not to work correctly. In this case, reposition the main unit to avoid direct lighting.
22