Yamaha AX-492, AX-592, AX-892, AX-592, AX-892 BASIC OPERATIONS, 1,6, PLAYING A SOURCE

BASIC OPERATIONS

		NATURAL SOUND STEREO AMPLIFIER AX-892																CD DIRECT AMP			PURE DIRECT
																			INPUT		VOLUME
																						16
2																			CD		20	12	1,6
														6 7				TAPE 1	TUNER
			– 5		5 +	– 5		5 +		L 5		5 R	5					TAPE 2	PHONO	28		8
	POWER		1	0	1	1	0	1		1	0	1	1	FLAT	TAPE 1	CD	TUNER
			2		2	2		2	ON OFF	2		2	2	-30db	TAPE 2		PHONO
														10	(MD)					40		4
			3		3	3		3		3		3	3	9	AUX			AUX
			4		4	4		4		4		4	4	8
									SUBSONIC											60		2
				BASS		TREBLE			FILTER	BALANCE			LOUDNESS		REC OUT
																					∞	0
																						-db
	PHONES	SPEAKERS
		A	B																		MUTING
		ON	OFF																		ON	OFF
																				(AX-892)
		4							7										3

*The AX-492 does not have a SUBSONIC FILTER and MUTING switch.

*The AX-592 does not have a MUTING switch.

PLAYING A SOURCE

1 Turn the control to “∞ ”.

	VOLUME
	16
20	12
28	8
40	4
60	2

∞0

-db

2 Turn the power on.

POWER

3 Select the desired input source.

	INPUT
	CD
TAPE 1	TUNER
TAPE 2	PHONO
(MD)
AUX

AX-592 and AX-892 only

*If you select PHONO as an input source, you should make sure that PHONO (MM/MC) is switched to the correct position. (Refer to page 10.)

4 Select the speakers to be used.

SPEAKERS

A B

ON OFF

*Be sure that the IMPEDANCE SELECTOR switch is correctly set as explained on page 11.

*If you use two speaker systems, press both the A and B switches to ON.

*If you listen with headphones, press both the A and B switches to OFF.

5 Play the source.

6 Adjust the volume to the desired level.

	VOLUME
	16
20	12
28	8
40	4
60	2

∞0

-db

7 If needed, adjust the BASS, TREBLE, BALANCE LOUDNESS, etc. controls. (Refer to page 18.)

Note

To turn off the power, press the POWER switch again.

16