CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.

English

1.To assure the finest performance, please read this manual carefully and keep it in a safe place for future use.

2.Install this unit in a cool, dry and dust-free area. Do not place it in direct sunlight or near sources of heat (e.g., a stove, etc.). Make sure that it is well ventilated and not exposed to rain or moisture and that it is on a flat, stable surface, free from vibration.

3.Never open the cabinet. If something drops into the unit, contact your dealer.

13.Voltage Selector (General Model only)

The voltage selector on the rear panel of this unit must be set for your local main voltage before plugging into the electrical outlet.

Voltages are 110/120/220/240 V AC, 60/50 Hz.

WARNING

To reduce the risk of fire or electric shock, do not expose the unit to rain or moisture.

IMPORTANT

4.When moving the unit, first disconnect the AC power plug and the cables which are connected to other equipment. Never pull the cables or use excessive force on switches or controls.

5. The openings on the cabinet assure proper ventilation of the unit. If these openings are obstructed, the temperature inside the cabinet will rise rapidly, damaging the unit or causing a fire. Avoid blocking the ventilation openings and make sure that the unit is well ventilated. Allow at least 30 cm (12 in) of space above the unit and 20 cm (8 in) of space on the sides and rear.

6.Always set the VOLUME control to “∞ ” before playing the source. Increase the volume gradually to a desired level after the source has started playing.

7.Use a clean, dry cloth to clean the unit. Do not use chemical solvents which might damage the finish.

8.Be sure to read the “TROUBLESHOOTING” section before deciding that the unit is faulty.

9.When not planning to use this unit for long periods of time (e.g., vacation, etc.), disconnect the AC power plug from the electrical outlet.

10.To prevent damage from lightning, disconnect the AC power plug and antenna cable when there is an electrical storm.

11.Make sure that the unit is always properly grounded and polarized.

12.Do not connect audio equipment to the AC outlet on the rear panel if the equipment requires more power than the outlet is rated to provide.

The serial number is located on the rear panel.

Please record the serial number of this unit in the space below.

Serial No.:

Keep this Owner’s Manual in a safe place for future use.

Note

The unit is not disconnected from the AC power source as long as it is connected to the electrical outlet, even if the unit itself is turned off.

CAUTION (FOR CANADA MODEL)

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT AND FULLY INSERT.

FOR CANADIAN CUSTOMERS

THIS CLASS B DIGITAL APPARATUS MEETS ALL REQUIREMENTS OF THE CANADIAN INTERFERENCE- CAUSING EQUIPMENT REGULATIONS.

WARNING

Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged.

IF THIS UNIT FAILS TO TURN ON WHEN THE POWER SWITCH IS PRESSED

The IMPEDANCE SELECTOR switch may not be set to either end closely. If so, set the switch to either end closely.

IMPEDANCE

VOLTAGE SELECTOR

SELECTOR

 

AC OUTLETS

SWITCHIED

100W MAX. TOTAL

A OR B : 4Ω MIN. /SPEAKER

A + B : 8Ω MIN. /SPEAKER

A OR B : 6Ω MIN. /SPEAKER

A + B :12Ω MIN. /SPEAKER

Example: AX-892

<General model>

5