CONNECTING SPEAKERS

Connect the SPEAKERS terminals to your speakers with cable of the proper gauge, cut as short as possible. If the speakers are improperly connected, no sound will be heard. Connect each speaker making sure that the polarity (+ and –) is correct.

Red: positive (+)

Black: negative (–)

If the cables are reversed, the sound will be unnatural and will lack bass. Do not allow exposed wires to touch each other

or metal parts; this could damage the unit and speakers.

●One or two speaker systems can be connected to this unit. If you connect only one speaker system, connect it to either SPEAKERS A or B terminals.

●Use speakers with the specified impedance shown on the rear panel.

English

For AX-492’s SPEAKERS A and B terminals and for AX-592’s SPEAKERS B terminals only:

➀Unscrew the knob.

For AX-592’s SPEAKERS A terminals only and for AX-892’s SPEAKERS A and B terminals:

➁ Insert the exposed wire.

2

[Remove approx. 5 mm

1

(1/4 in) insulation from

 

the speaker wires.]

 

➂ Tighten the knob and

3

secure the wire.

1

2

Banana plug connections are also possible. Simply insert the banana plug connector into the corresponding terminal. (except for UK and Europe models)

3

➀Unscrew the knob.

➁Insert the exposed wire. [Remove approx. 5 mm (1/4 in) insulation from the speaker wires.]

➂Tighten the knob and secure the wire.

REAR PANEL PARTS

AC OUTLETS (SWITCHED)

Use these to connect the power cords from your components to this unit.

The power to the SWITCHED outlets is controlled by this unit’s POWER switch or the remote control’s POWER key. These outlets will supply power to the connected components whenever this unit is turned on.

The maximum power (total power consumption of components) that can be connected to the AC OUTLETS (SWITCHED) is 100 watts.

9