Manuals / Brands / Home Audio / Speaker / Yamaha / Home Audio / Speaker

Yamaha CC-70S, CC-70W Auxiliary (AUX), Turntable (PHONO), USING EXTERNAL UNITS

1 51

Download 51 pages, 4.63 Mb

USING EXTERNAL UNITSAuxiliary (AUX)

1 Connect the output lead of a video cassette player, video disc player, etc. to the AUX inputs of this unit.

(red → right channel, white → left channel)

Press the AUX input selector button.

Operate the unit connected to the AUX inputs.

Start recording with this unit, if so desired. (See page 38.)

Turntable (PHONO)

1 Connect the output lead of a turntable. (red → right channel, white → left channel)

Connect the GND lead of a turntable.

Press the PHONO input selector button.

Operate the turntable.

Start recording with this unit, if so desired. (See page 38.)

Contents

Natural Sound Mini Component System Active Servo Technology * For U.K. and Europe models, NX-S70is optional in some areas IMPORTANT (for U.S. customers) SPECIAL NOTES FOR FCC COMPOSITE DEVICE We Want You Listening For A Lifetime INTRODUCTION For U.K. and European customers FEATURES 3-CDCarousel Auto Changer Continuous Tape Playback Capability by WARNING CD Player (CDC-S90) Disc Table Stop Button: Play/Pause Button: Disc Select Buttons Double Cassette Tape Deck (KXW-S70) DECK A Cassette Compartment DECK A Select Button and Indicator DECK B Select Button and Indicator DECK B Cassette Compartment Rear Panel of Receiver 1. Antenna Terminals and Terminals (U.K. and Europe models only) Remote Control Transmitter Window Preset Station Number Buttons A, B, C, D, E Selector Buttons VOLUME Down (–)/Up(+) Buttons Track Number Input Buttons 22.Play Button: 23.Stop Button: 24.Play Button: 25.Fast Wind Button: 26.DECK A/B Select Buttons (for KXW-S70only) Proper use of the remote control transmitter Notes concerning use REMOVING THE FRONT GRILLE (for Speaker System NX-S70only) Note PREPARATION FOR USE Placing the system Notes Antenna connection (1) Supplied FM antenna (2) Supplied AM (MW/LW) loop antenna Speaker connection Connect each speaker wire to the SPEAKERS terminals Cautions [For U.S.A., Canada, Australia and General models] NX-S70 OPEN/CLOSE THE CONTROL DOOR TURNING THE POWER ON/OFF TO THIS SYSTEM STANDBY mode SETTING THE CLOCK Changes The hour setting will not advance even if the minute advance from “59” to “00” To display the time by “second” To reset the second to “00” Volume Front panel operation Remote control operation Balance Tone CD playback 3 Place discs on the trays, label side up *Up to three discs can be loaded on the trays *8 cm (3”) discs may be played without an adaptor 4 Press the OPEN/CLOSE button to close the disc table Direct-selectionplay A. For example, to choose selection Press the “5” button B. For example, to choose selection (1)Press the “+10” button Skip search Manual search Display information during programming Playback order Selected track number Program play You can program up to 20 tracks in any desired order 2 When in the stop mode, press the PROGRAM button to prepare for programming “PROG” and 3 If necessary, select a desired disc by pressing the DISC SKIP button To stop program play •Press the stop button. The first track number programmed will be displayed To resume playback, press the play/pause To cancel a programmed sequence There are several methods as described below Repeat play modes Random play To cancel the random play Switching the time display [Example] Press the TUNER input selector button Automatic tuning 3 Press the AUTO/MAN’L button so that “AUTO TUNING” appears on the display (In this mode, stations are received in stereo or monaural automatically.) Manual tuning 1 Follow steps 1 and 2 of the Automatic tuning method Preset tuning To store stations (Example: To store a station to A1) (In this case, select area A) (In this case, select “1”.) Automatic preset tuning After the automatic preset tuning is completed Fundamental rules of internal automatic preset tuning Memory back-up operation General information DECK A select button DECK B select button Tape A or tape B playback Winding the tape Searching for the beginning of a desired selection To listen to the same selection To listen to the next selection Continuous playback 1 Load the tapes into the DECK A and DECK B cassette compartments 2 Set the reverse mode switch to 4 Press the play button to listen to side A, or the Dolby B and C Type Noise Reduction Tape playback 2 Open the cassette compartment by pressing the OPEN/CLOSE button 6 Press the play button to listen to side A, or the play button for side B Tape Counter (LINEAR COUNTER) and RESET button REMAIN indicators Dolby HX PRO Dynamic Bias Servo System Page Press the CD input selector button and load the disc to be recorded RECORDING COMPACT DISCS Tape Deck (KXW-S70) Tape Deck (KX-S90) CD synchronized recording 2 Load a tape into the cassette compartment 4 Set the reverse mode switch as desired 5 Press the REC/PAUSE button To stop recording temporarily To stop recording Recording programmed tracks Recording CD(s) on both sides of a tape automatically To cancel this function Automatic tape-editing To record a disc with the order of tracks unchanged appear on the display in turn, and next it returns to the normal display mode off → C-46 → C-54 → C-60 → C-90 CD player To cancel tape-editingfunction Follow steps 3–6 on page Selected disc Side of the tape Recording from the built-intuner 5 Set the reverse mode switch to to record on only one side, or to (or ) for continuous recording on both sides 6 Press the REC/PAUSE button *The corresponding indicator lights up and the play direction indicators flash Dubbing (by using KXW-S70only) To stop dubbing Erasing recorded tapes HOW TO USE THE BUILT-INTIMER Timer play For tuner: For tape deck: For CD player: Setting procedure: ➂ At ON TIME/time setting mode ➃ At OFF TIME/time setting mode TIME ADJ TIMER 2-➂, ➃ To cancel the timer play setting Timer recording (To record a tuner program) To confirm the timer time setting To cancel the setting of timer recording Play the desired sound source Sleep timer operation This unit can be turned off automatically OFF SLEEP (Sleep timer is off.) *The SLEEP indicator illuminates to indicate that the sleep timer is on Auxiliary (AUX) Turntable (PHONO) MAINTENANCE KXW-S70(DECK A) KXW-S70(DECK B) Headphones Internal care •Dirty heads, capstans and pinch rollers can cause poor sound and tape jams <For KX-S90 Clean these parts with a commercially available SPECIFICATIONS ■ Receiver (RX-S70) Minimum RMS Output Power per Channel 50W+50W 6 ohms, 1 kHz, 10% THD TROUBLESHOOTING ACTIVE SERVO TECHNOLOGY (for Speaker System NX-S70only)