Display information during programming

PROG

➀

➁➃

PROG

6

➂

➀Shows the program number for the track to be programmed next.➁Shows the selected disc and track number.➂Shows the total time of the tracks currently programmed.➃ Shows only the numbers of programmed tracks on the selected disc.

*If “STEP 1” does not appear on the display after the PROG button is pressed, press the TIME display mode-select button.

*If the total time exceeds 99 minutes and 59 seconds, the time will not be displayed.

Notes

●You can program as many as 40 tracks at one time.

●You can program a whole disc by pressing “0”, instead of one track. At that time, “ALL” lights up in the display.

●The total time of the programmed tracks will not be displayed, if a track number higher than 20 is programmed.

●If, during programming, the TIME display mode-select button is pressed, the program number display can be changed to display the total time of the programmed tracks or no information. To return to the previous display, press the TIME display mode-select button once again.

●Pressing a numeric button stops the current program and skips to the beginning of the track of the number pressed. Once that track has finished playing, the previously interrupted program resumes play.

●To skip tracks within the program, press the SKIP/SEARCH( and ) buttons during play.●To search all tracks including unprogrammed tracks, pressand hold the SKIP/SEARCH ( and ) buttons during play.

English

To stop program playPress the STOP button. The first programmed track number will be displayed.

To resume play, press the PLAY button. Play will begin from the beginning of the program.

To cancel a programmed sequenceThere are several methods, as described below.●Press the STOP button or the CLEAR button while the unit is stopped.●Open the disc tray.●Switch off the power.
To check program data1.During program play, press the STOP button.2.Press the PROG button.

3.Each time the SKIP/SEARCH button is pressed, the track numbers and sequential order of the programmed tracks can be checked one after another. The display of the track number can be returned (sequentially in reverse

order) by pressing the SKIP/SEARCH button.To correct program data1.Follow the procedure described in “To check program data”.2.Display the track number to be corrected by pressing the SKIP/SEARCH buttons.

3.Press a numeric button to select a track to replace the one displayed. The previously programmed track will be cleared from the memory and the new one will be programmed.

4.After the correction has been completed, press the PROG button or PLAY button once again.

15