This manual describes how to operate this unit by using the remote control transmitter.
To operate this unit on the front panel, use the corresponding buttons on the front panel.
BASIC OPERATION
| SYNCHRO | DIMMER | TIME | OPEN/ | 2, 3 |
| CLOSE | ||||
| SPACE PEAK | TAPE | CLEAR | PROG | |
| 1 | 2 | 3 | INDEX |
|
|
|
|
|
| |
| 4 | 5 | 6 | +I0 |
|
| 7 | 8 | 9 | 0 |
|
STANDBY/ON |
| REPEAT RANDOM |
| ||
1 |
|
| |||
|
| SEARCH |
| ||
|
|
| SKIP |
|
|
| STOP | PAUSE | PLAY |
| 4 |
|
|
|
|
| |
1 Turn the power on. | 3 Close the disc tray. |
|
|
| |
STANDBY/ON |
|
|
|
|
|
OPEN/
CLOSE
2 Load a disc. | Label side | 4 |
| upward | |
|
| |
OPEN/ |
| PLAY |
CLOSE |
|
|
Disc tray | Play will begin from the first track of the disc. |
| Display information at disc play |
| Notes |
|
| • After closing the disc tray by pressing the OPEN/CLOSE |
|
| button, the display shows the total number of tracks and the |
1 | 2 | total recorded time of the disc for a few seconds. |
|
English
1Shows the track number selected or being played.
2 Shows the time displays. (Refer to “Selecting time displays” on page 10.)
TOTAL
•Additionally, you can close the disc tray by pressing the PLAY (PLAY/PAUSE) button, a numeric button or the RANDOM button, or by pressing the front edge of the disc tray gently. If the tray is closed in these ways, play will begin automatically, however, the display will not show the total number of tracks and the total recorded time of the disc.
Press the STANDBY/ON switch again to turn this unit into the standby mode.
Standby mode
In this state, this unit is not disconnected from the source as long as it is connected to the wall outlet, even if this unit itself is turned off.
7