2. Attach B.

Depending on the model of Clavinova you pur- chased, the surface color of one side of B may be different from the other side. In this case, position B so that the side of the surface color similar to D and E faces the player.

2-1Place the lower side of B on each foot of D and E, then attach the upper side to D and E.

2-2Attach the top of B to D and E by finger- tightening the thin screws 3 (4 ⋅ 12mm).

2-3While pushing the lower part of D and E from outside, secure the bottom ends of B using two tapping screws 4 (4 ⋅ 20mm).

2-4Insert the other two tapping screws 4 (4 ⋅ 20mm) into the other two screw holes to secure B.

2-5Securely tighten the screws on the top of B that were attached in Step 2-2.

E

2-2, 2-5

2-1

 

Place the bot-

B

tom ends of the

D

rear panel on

 

each foot.

 

2-3

2-4

2-3

3. Securely tighten the screws on C that were attached in Step 1-3.

B

C

3

Keyboard Stand Assembly

4. Mount A.

Be sure to place your hands at least 10 cm from either end of the main unit when positioning it.

A

At least

E10 cm

D

B

CAUTION

•Fingers can become pinched between the main unit and the rear or side panels, be extra careful so as not to drop the main unit.

•Do not hold the keyboard in any position other than the position shown in the illustration.

5. Secure A.

5-1Adjust the position of A so that the left and right ends of A will project beyond D and E equally when seen from the front.

5-2Secure A by tightening the short screws 2 (6 ⋅ 16mm) from the front.

5-1

A

Projection

of A

A

5-2

ENGLISH

33

CLP-320Owner’s Manual 35