CVP-409/407 Owner’s Manual 213
Appendix
CVP-409/407: Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all
parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below.
Use of incorrect screws can cause damage.
• Be sure to tighten up
all screws upon com-
pleting assembly of
each unit.
•To disassemble,
reverse the assembly
sequence given below.
1Remove all parts from the box. Confirm that all
parts shown in the illustration are provided.
2With the key cover closed and the keyboard side
on the bottom, lean the unit against the wall.

Spread a large soft cloth, such as a blanket, on the floor.

Place the unit on the cloth with the keyboard side on

the bottom and lean the unit against the wall so that the

unit will not fall or slip. Place a soft cloth against the

wall to protect the instrument and wall from scratches.

CAUTION
• Be careful not to pinch your fingers.
• The top part of the music rest is not fixed. When you lean
the unit against the wall, support the music rest with your
hand so that the music rest will not fall.
CAUTION
• Do not place the main unit
with the rear side facing
down.
• Do not lay the main unit
upside-down on the floor.
3Attach the front legs.
4Attach the rear leg.
5Raising the unit to the standing position.
Use the front legs as support to raise the unit.
CAUTION
• Be careful not to pinch your fingers.
•When you raise the unit, do not hold the key cover.
Have a Phillips-head (+) screw-
driver ready.
Rear legFront leg (left)
AC power cord
Front leg (right)
Pedal box
5x18 mm fixing
screws × 14
Bundled pedal
cord inside
CAUTION
To prevent the
key cover from
accidentally
opening during
assembly, press
down on the
key cover, mak-
ing sure that
the sheet
(shown) remain
in place.
Be sure to position the keyboard side on the bottom.
CAUTION
Please do not touch the speaker
net. Doing so may damage the
speaker inside.
Incorrect
Incorrect
Front leg (right) Front leg (left)
1Fix the front right
leg to the bottom
surface of the unit
using two screws.
2Fix the front right leg
to the speaker box
using two screws.
3Fix the front left leg in the same way.
If the screw holes do not align, loosen the other screws and
adjust the position of the front leg.
2Fix the rear legs to the
speaker box using two
screws.
1Fix the rear legs to
the bottom surface
of the unit using
two screws.
If the screw holes do not align, loosen the other screws and
adjust the position of the rear legs.