Chapter 2 - Installing the Yamaha CRW4001t Drive
♦Setting the CRW4001t as the MASTER
As shown in the diagram at the right, insert the jumper pin into the right edge of the jumper T switch.
Note: If only the CRW4001t will be connected to the IDE interface connector, connect the CRW4001t to the end of the connector.
CSEL
SLAVE
MASTER
IDE INT
♦Setting the CRW4001t as the SLAVE
As shown in the diagram at the right, insert the jumper pin into the middle of the jumper switch. T
♦CSEL (Cable SELect)
CSEL
SLAVE
MASTER
IDE INT
If you use the CSEL setting, the MASTER/SLAVE setting will be made automatically depending on the hardware configuration.
For details refer to the manual of your computer.
6